Wire harness processing is prior to Emerson electronics. The common sense of wire harness processing is as follows

1: The wire is stained with tin.

If the wire is stained with tin, the PVC may shrink when heated. In this case, choose temperature resistant PVC, control the time of tin not too long.

2: How to carry out cable line reliability test.

Generally, shaking, hanging weight and conduction performance tests are needed. General simple horn model swing test conditions: swing frequency, simple horn model selection, lifting load, swing required times and other parameters. The conditions of the test include three parameters: load, time and displacement.

3: The label is not sticky.

If the label is not pasted, do not touch the non dry adhesive tape directly with your hands. The needle and mother system is pasted on the clean metal, and then pasted on the line.

4: The tension is insufficient after pressure.

If the tensile force can not be reached, the reason can be found from the aspects of whether the crimping range of the terminal and wire conductor is appropriate, the blade material and its structure design, the terminal material, etc.

5: The terminal is separated from the pin when the rubber shell is penetrated.

When wearing the rubber shell, the terminal is often separated from the pin, how to solve it? In fact, every time you insert it into the hole, you can pull it back.